Bloxygen

Problem: Oxygen or moisture sensitive products dry out, cure, and harden during storage. When we store these products, the oxygen or moisture that's sealed in the container continues to cure and thicken the product, eventually forming a skin over the top. This skin is wasteful, time consuming, and messy to remove. Sometimes, hardened particles can clog spray guns, run the final finish, or destroy the remaining liquid.

Solution: Simply, we need to prevent any oxygen or moisture from reacting with the product. By using a blanket of protective inert gas to purge the container, you can store your finish safely and use ALL your finish, not just the first half.

How does it work? Bloxygen uses ultra pure Argon, a powerful and natural inert gas to drive the oxygen out of your container. Simply blow the oxygen out of your container with Bloxygen and then seal the lid. The heavy, inert Bloxygen gas sinks down to block oxygen from the liquid surface. Because Bloxygen is heavier than air, it will separate the liquid surface from any air that may remain in the container.